30
Switching ON
ANUBIS
1.
Press the switch on the unit’s rear panel next to the DC input, as shown on the Back
-Panel figure.
Pressed = ON
Released = OFF
2.
The Anubis Soft buttons will light up orange when the unit initiates the boot-up sequence, the TFT
display will follow soon after. During this time the unit will perform a series of self-test and
initialization routines.
3.
Once the Anubis TFT display shows the Home page, the unit is ready for use.
Note: To turn OFF Anubis, press the POWER button to the Released state.
4.
Select your Anubis Mission. To navigate between pages, press the Anubis Home pyramid
button. Hold the pyramid button for 1 second to return to the Home page.
The Anubis Home page provides access to the Settings and Preamps pages and the Logs
(messages) . The Home page is not in the 3 Main pages cycle. It can anytime be accessed by
long pressing the Anubis Home button.
More details on the Anubis main pages and settings in the Monitoring Mission chapter.
Summary of Contents for Anubis Premium
