OUTBOARD INSTALLATION
112
Prime the oil injection pump as follows:
1. Fill the engine fuel tank with fuel.
NOTE: Use the primer bulb located in the fuel hose to the engine
to draw fuel from the tank to fill the engine fuel system.
2. Position the fuel hose primer bulb so that the arrow on the side
of the bulb is pointing up. Squeeze the fuel hose primer bulb
until it feels firm.
27348
3. Turn the ignition key switch to the "ON" position.
26846
4. Within the first 10 seconds after the key switch has been
turned on, move the remote control handle from neutral into
forward gear 3 to 5 times. This will automatically start the
priming process.
NOTE: It may take a few minutes for the pump to complete the
priming process.
Trim In Pin
!
WARNING
Operating the boat at high speeds with the outboard trimmed too
far under can create excessive bow steer, resulting in the
operator losing control of the boat. Install the trim limit pin in a
position that prevents excessive trim under and pilot the boat in
a safe manner.
Summary of Contents for Optimax
Page 4: ...iv ...
