Section 5 - Maintenance
Page 78
90-879172181
eng
FEBRUARY 2011
Task Interval
Maintenance to be Performed
After the first 25 hours of
operation and not to exceed
30 hours of operation
•
Change the transmission oil (fluid) and filter, including the transmission oil in the drop box,
if equipped.
•
Change the gear lube in the drive gearcase and gear lube monitor. (The task can be
performed with the vessel in the water.)
Every six months
•
Check the trim tab anodes. Replace the anodes if they are eroded 50 percent or more.
Every 250 hours of operation
or once a year (whichever
occurs first)
•
Tighten the driveshaft connecting bolts and nuts to specification.
•
Inspect and lubricate the driveshaft slip‑joint.
•
Inspect the driveshaft U‑joints; lubricate if equipped with grease fittings.
•
Change the gear lube in the drive gearcase and gear lube monitor.
•
Change the transmission oil (fluid) and filter, including the transmission oil in the drop box,
if equipped.
Every 500 hours of operation
or once a year (whichever
occurs first)
•
Lubricate the propeller shaft splines and tighten the propeller nuts to specification.
•
Inspect the hydraulic system fittings and hoses found on the drive for leaks or damage.
Check the hose fittings for tightness.
•
Check the bonding (continuity) circuit for loose or damaged connections. Test the
MerCathode® unit output.
•
Inspect the electrical system for loose, damaged, or corroded fasteners. Check for lose,
damaged or corroded wiring and connectors.
•
Inspect the cooling system components found on the drive for damage or leaks. Check the
hose clamps on the hoses for tightness.
•
Check that the water inlet openings on the seawater pickup are clean and not obstructed.
•
Inspect the exhaust system connections on the drive for damage or leaks. Check the hose
clamps on the hoses for tightness.
•
Treat the power package components inside the boat with Corrosion Guard to protect the
product from corrosion.
Every 2000 hours of operation
or four years (whichever
occurs first)
•
Replace the driveshaft U‑joints—QSC models only.
Whenever the VesselView
fault code "Filter Dirty Fault",
"Filter Clog Fault", or "Service
Steering Filter" is displayed
•
Change the hydraulic oil and filter for the steering and trim system. (Refer to the information
about changing the steering actuator and trim hydraulic oil.)
Maintenance Log
Record all maintenance performed on your power package here. Be sure to save all work orders and receipts.
Summary of Contents for 92-858058K01
