DTS DUAL CONSOLE REMOTE CONTROL WITH CAN TRACKPAD
90-889224 MAY 2006
Page 11 / 17
NOTE: Verado and Bravo III are always normal shift polarity.
6. Select the lever to be adapted. In a dual engine application, ensure the engine location
matches the ERC handle selected. Press the "Next" button.
7. Move the control handles according to the instructions on the screen. Press the "Next"
button after each time the control handle is moved. After all handles have been
adapted press the "Finished" button.
8. Turn the ignition key switch to the "OFF" position for all engines and return all control
handles to the neutral position. Press the "Next" button.
9. DTS Handle Adaptation is now complete.
CAN Trackpad Calibration
1. Connect the CDS tool to the junction box.
2. Ensure that the ignition key switch is in the "RUN" position, and that the CDS tool is
communicating with the command module.
NOTE: If the red Mercury SmartComm icon is flashing, the system cannot establish a
connection with the SmartComm interface box. If the yellow Mercury SmartComm icon
is flashing, the SmartComm interface box is detected, but communication with the
command module cannot be established. Check the connections, and ensure the ignition
key is turned on.
3. Click on the Engine Select button to enter engine information. To calibrate the CAN
Trackpad:
a.
Select the engine make. "GENERIC" may also be selected.
b.
Set the model to "DTS Command Module".
c.
Enter the number of engines.
d.
Enter the engine serial number and click the OK button.
4. If necessary, click on the Toolbox button. Click on the Calibration and System Info
button.
5. Click on the Trackpad tab.
NOTE: A CAN trackpad city ID will appear in the helm 1 location. This is the default
factory setting for all CAN trackpads regardless of engine helm configuration.
NOTE: If there are no CAN trackpads connected to the system, the screen will show
there are no trackpads detected. If the number of trackpads connected to the system
exceeds 15, the screen will display a message saying there can be a maximum of 15
trackpads attached to the DTS system until the number is within range.
Configuring the CAN Trackpad
IMPORTANT: The CAN trackpad configuration sets the location of each trackpad
connected to the DTS system. A CAN trackpad configuration must be completed on any
remote control or dash mounted trackpad installation regardless of the number of
trackpads.
1. Click on the "Trackpad" tab. The total number of trackpads will appear.
NOTE: The cell is highlighted to show that there is more than one CAN trackpad with the
same city ID.
2. Select the number of helms. Press the "Configure" button.
3. Ensure the ignition key switches for all engines are in the "RUN" position. Select the
number of trackpads on helm 1 and press the "Next" button.
NOTE: There can be a maximum of 15 trackpads connected to the DTS system.