Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 98 / 190

Section 4 - Main Menu
90-8M8022154 APRIL 2008 Page 91
Clock/Light
The settings for the clock are found in the "CLOCK/BRIGHTNESS" screen. Menu path:
"Main" > "Settings" > "Clock/Light". Press the check button to open the "CLOCK/
BRIGHTNESS" screen.
a
b
c
d
27135
a - Hours
b - Minutes
c - 12/24 Hour Display
d - Brightness
1. Upon entering the "CLOCK/BRIGHTNESS" screen, the "HOURS (0‑23)" field will be
highlighted in blue.
2. Press the left or right arrow on the arrow trackpad to select the hour of the day based
on a 24 hour clock even if you use a 12 hour clock display.
3. Press the down arrow on the arrow trackpad to proceed to the "MINUTES" field.
4. Press the left or right arrow on the arrow trackpad to select minutes after the hour.
5. Press the down arrow on the arrow trackpad to proceed to the "12/24 HR DISPLAY"
field.
6. Press the left or right arrow on the arrow trackpad to choose between the 12 and 24
hour clock display.
7. Press the down arrow on the arrow trackpad to proceed to the "BRIGHTNESS" field.
8. Press the left or right arrow on the arrow trackpad to adjust screen brightness. The right
arrow increases brightness and the left arrow decreases brightness.
9. Once you have selected the preferred clock settings, press the check button to save
the session.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.