Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 97 / 190

Section 4 - Main Menu
Page 90 90-8M8022154 APRIL 2008
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.
STEERING
The "STEERING" screen enables you to set the display data in the Vessel screen
"STEERING POSITION". Refer to
Section 6 - Vessel
. Menu path: "Main" > "Settings" >
"Screen Options" > "Steering". Press the check button to open the "STEERING" screen.
1. Use the left or right arrow on the arrow trackpad to scroll through the options in the
"LEFT DATA AREA" field. Choose which information to display in the field appearing
on the bottom left of the "STEERING POSITION" screen. The available options are:
•
"BOAT SPEED" ‑ Vessel speed
• "WIND DIR" ‑ Wind direction
• "WATER DEPTH" ‑ Water depth
• "GEAR POS" ‑ Gear position
• "WIND SPEED" ‑ Wind speed
STEERING
LEFT DATA AREA
RIGHT DATA AREA
STEERING OFFSET
0
WATER DEPTH
BOAT SPEED
O
a
b
c
27273
a - Left data area box
b - Right data area box
c - Steering offset box
2. Press the down arrow on the arrow trackpad to proceed to the "RIGHT DATA AREA"
field.
3. Use the left or right arrow on the arrow trackpad to choose which information to display
in the field appearing on the bottom right of the "STEERING POSITION" screen.
4. Press the down arrow on the arrow trackpad to proceed to the "STEERING OFFSET"
field.
5. Use the left or right arrow on the arrow trackpad to adjust the steering position up to
60 degrees in either direction.
6. Once you have selected the "STEERING POSITION" screen display data, press the
check button to save the session.
NOTE: Upon completing any change/customization to VesselView a blue pop‑up message
will appear as a reminder to save your session. Refer to
Section 1 - Saving Settings
. To
save time, it is recommended that all session changes be saved before holding
X
button
while keying ALL engines off.