Mercury Racing VesselView, Installation, Calibration & Operation Manual

Page: 47 / 190

Section 2 - Initial Setup and Calibration
Page 40 90-8M8022154 APRIL 2008
Complete
The setup wizard displays the "COMPLETE" screen after you have completed all the steps
of the setup wizard. To review your choices or to go back to a screen to make corrections,
use the left arrow on the arrow trackpad.
32250
When you are sure that your changes are correct, press the check button to save your
session and restart the VesselView unit. VesselView displays a saving settings message,
then restarts. The restart process may take a few minutes.
NOTE: If you want to change the vessel configuration after exiting the setup wizard, you
may either restart the wizard by choosing Reset Settings Directory on the "FACTORY
RESET" screen in the "Calibrate" menu or reconfigure the vessel using the "Vessel Config"
menu.