Mercia Garden Products 02LRGTWR-V1 Manual Download Page 1

02LRGTWR-V1

MADE IN GREAT BRITAIN

PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE

For Assistance Please 

Contact Customer Care on 

01636 880514

x2

Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

This building should be erected by 

two Adults.

For ease of assembly, it is advisable to 

pilot drill all screw holes and ensure 

all screw heads are countersunk. We 

recommend using a 2mm, 5mm and 

8mm drill bit.

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY 

- Check the pack and make sure you have all the parts listed. 

- When you are ready to start, make sure you have the right tools at hand 

(not supplied) including  a Phillips screwdriver, Utility knife, wood saw, and 

drill with 2mm, 5mm and 8mm bit.

- Ensure there is plenty of space and a clean dry area for assembly. 

- Make sure you have a suitable base ready to erect your building and is 

accessible all the way around to enable any maintenance to be carried out 

if needed. 

TIMBER

As with all natural materials, timber can be affected during various weather 

conditions. For the duration of heavy or extended periods of rain, swelling 

of the wood panels may occur. Warping of the wood may also occur during 

excessive dry spells due to an interior moisture loss. Unfortunately, these 

processes cannot be avoided but can be helped. It is suggested that the 

outdoor building is sprayed with water during extended periods of warm 

sunshine and sheltered as much as possible during rain or snow. 

BUILDING A BASE

When thinking about where the building and base is going to be 

constructed: Ensure that there will be access to all sides for maintenance 

work and annual treatment. 

WE DO NOT RECOMMEND UNDER ANY CIRCUMSTANCES ERECTING 

THE BUILDING DIRECTLY ONTO GRASS OR SOIL BASE.

Whilst all products manufactured are made to the highest standards of Safety and in the case of childrens products independently 

tested to EN71 level. We cannot accept responsibility for your safety whilst erecting or using this product. 

Mercia Garden Products Limited, Sutton On Trent, Newark, Nottinghamshire, NG23 

CONTENTS

CHECK ALL PARTS LISTED ARE IN THE KIT BEFORE ASSEMBLY

BASE DIMENSIONS

Length - 2156cm

Width - 1768cm

Bunk Floor

50mm Screw x 22 

40mm Screw x 25 

30mm Screw x 20

100mm Screw x21

150mm Screw x10

70mm Screw x 25

2

1

3

4

5

6

7

8

9

10

11

12

13

14

15

WARNING: Only for domestic use

Not suitable for children under 36 month

To be used under direct supervision of an adult

12x121x1153mm

Slide

Long Rail

Short Rail x2

12x121x405mm

70x70x1625mm x2

70x70x900mm x2

70x70x670mm

44x60x762mm x8

Ladder Side Left

Ladder Side Right

27x95x390mm x4

44x44x475mm

12x60x600mm x7

TYPES OF BASE

- Concrete 75mm laid on top of 75mm hard-core, no be bigger than the 

dimensions of base. 

- 4 x 2ft concrete pads at 75mm laid on top of 75mm hard core.

We recommend applying an impact reducing surface around the base and 

slide, also

 

a

 2 metre safety perimeter should be set up around the building 

free from obstacles and potential hazards.

Maintenance should be carried out at regular intervals. If checks are not carried out the product could overturn or other-

wise become a hazard

- Check at the beginning of each season and at regular intervals

- Check all nuts, blots and screws for tightness, tighten when required.

- Check swing seat, clamps, ropes and other means of attachment for evidence of deterioration

- Replace defective parts in accordance with the manufacturers instructions

OVERALL AREA 

(May differ depending on set up)

Length - 383cm

Width - 420cm

Summary of Contents for 02LRGTWR-V1








Reviews: