i
The respective differential lock is only dis-
engaged when the display shows
v
.
X
If the
£
indicator flashes, briefly change
your speed, e.g. pull away, brake or change
your direction of travel. Do not drive on.
X
If the
£
indicator does not go out when
the inter-axle locks are disengaged, stop the
vehicle and reverse it a short distance.
i
If the differential locks are engaged and
you drive faster than 50 km/h, the current
status of the differential locks is again
shown in the display. Disengage the differ-
ential locks or drive at a speed below
50 km/h.
Transfer case
Engaging the off-road gear
Engage the off-road gear to increase power to
the driven axles off-road.
Off-road gear is engaged when all the engage-
ment conditions are met. The display then
shows the
m
symbol.
The display goes out when the off-road gear is
disengaged and the road gear selected.
Even if all engagement conditions are met,
changing gear on vehicles with a manual trans-
mission can take up to three seconds.
If the off-road gear is selected on vehicles with
an automated manual transmission, the shift
range is automatically limited to upshifting.
If the inter-axle lock and ABS are activated
when driving off-road, it can lead to an inter-
ruption in the tractive power in the switch
positions
1
or
2
.
X
To engage off-road gear: stop the vehicle.
X
Shift into neutral.
X
Press the upper section of the
m
switch.
When all engagement conditions are met,
the off-road gear is engaged and the
m
symbol is shown in the display.
X
To disengage off-road gear: stop the vehi-
cle.
X
Shift into neutral.
X
Press the lower section of the
m
switch.
The off-road gear is disengaged when all
engagement conditions are met. If the road
gear is then reselected, the
m
indicator
goes out in the display.
Cold-start aid
H
Environmental note
At outside temperatures below approx-
imately
Ò
4 †, the cold-start aid minimises
pollutant emissions (after the engine is star-
ted). In addition, it reduces the load on the
starter motor and batteries and enables the
engine to be started more rapidly. For this
reason, only start the engine once the
%
indicator lamp in the status area of the on-
board computer has gone out.
The cold-start aid makes it easier to start the
engine at low outside temperatures (below
−15 †). It is activated at outside temperatures
below −4 †.
Operation
113
Driving mode
Z
Summary of Contents for Zetros 2020
