Operating the combination light switch
1
High beam
2
Right turn signal light
3
Headlamp flashing
4
Left turn signal light
#
Use the combination switch to select the
desired function.
Switching on high beam
#
Switch on the low beam (
/
page 84).
#
Push the combination switch forwards
1
.
The
K
indicator lamp on the instrument
cluster will light up. The combination switch
will return to its starting position.
%
In the
Ã
position, the high beam switches
on only in darkness and when the vehicle is
switched on.
#
To switch off: push the combination switch for-
wards
1
or briefly pull it in the direction of
arrow
3
(the action for headlamp flashing
switches high beam off).
The
K
indicator lamp on the instrument
cluster will go out. The combination switch will
return to its starting position.
%
Vehicles with Highbeam Assist: when High-
beam Assist is active, it controls the activation
and deactivation of the high beam
(
/
page 86).
Headlamp flashing
#
Briefly pull the combination switch in the direc-
tion of arrow
3
.
Turn signal light
#
To indicate: push the combination switch in the
required direction
2
or
4
until it engages.
When significant steering movements are
made, the combination switch will automati-
cally reset itself.
#
To indicate briefly: tap the combination switch
briefly in the required direction
2
or
4
. The
corresponding turn signal lamp will flash three
times.
Switching the hazard warning light system on/off
#
Press button
1
.
If you operate a turn signal indicator while the haz-
ard warning light system is switched on, only the
turn signal lamps on the relevant side of the vehi-
cle will light up.
%
The hazard warning light system will work even
when the vehicle has been switched off.
The cornering light improves the illumination of the
roadway over a wide angle in the turning direction,
e.g. enabling better visibility in tight bends.
85
