Control system
121
Resetting fuel consumption statistics
X
Press button
ÿ
or
è
repeatedly until
the first function of the
Trip computer
menu appears in the multifunction display.
X
Press button
j
or
k
repeatedly until
the reading that you want to reset appears
in the multifunction display.
X
Press and hold the reset button in the
instrument cluster until the respective
values are reset to
0
.
The fuel consumption statistics reset
automatically to 0 after 99
999 miles or
9
999 hours, whichever occurs first.
Distance to empty
X
Press button
ÿ
or
è
repeatedly until
the first function of the
Trip computer
menu appears in the multifunction display.
X
Press button
j
or
k
repeatedly until
the message
Range:
appears in the left
multifunction display.
The calculated remaining driving range
based on the current fuel tank level
appears in the right multifunction display.
If only very little fuel is left in the tank, a
vehicle at the fuel pump
¿
appears
instead of the remaining driving range.
A driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call. If you choose to use the
telephone while driving, please use the
hands-free device and only use the
telephone when weather, road and traffic
conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a
vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
You can connect your telephone to the
COMAND system via Bluetooth
®
, see
separate COMAND system operating
instructions.
X
Switch on the COMAND system.
Refer to separate COMAND system
operating instructions.
X
Press button
ÿ
or
è
repeatedly until
the message
TEL
appears in the left
multifunction display.
One of the following messages will appear
in the multifunction display:
R
No Service
: No network is available.
R
Bluetooth Ready
: The telephone has
not been connected to the COMAND
system via Bluetooth
®
yet.
X
Connect the telephone to the
COMAND system via Bluetooth
®
.
R
Ready
or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the right
multifunction display you will then see the
Controls in detail
230_AKB; 1; 42, en-US
d2ureepe,
Version: 2.11.7.1
2008-11-27T15:37:19+01:00 - Seite 121
Z