Mercedes-Benz GLS 2023, Operator'S Manual

Page: 400 / 538

Aluminum hub cap
#
To remove: position socket 2 from the tire-
change tool kit on hub cap 1 .
#
Position wheel wrench 3 on socket 2 .
#
Using wheel wrench 3 , turn hub cap 1
counter-clockwise and remove it.
#
To install: follow the instructions above in
reverse order.
% Specified tightening torque: 18 lb-ft (25 Nm).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 396).
Important notes on using the jack:
R
Use only a vehicle-specific jack that has been
approved by Mercedes-Benz to raise the vehi-
cle.
R
The jack is only designed for raising and hold-
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
R
The foot of the jack must be positioned verti-
cally under the jack support point.
Rules of conduct when the vehicle is raised:
R
Never place your hands or feet under the vehi-
cle.
R
Never lie under the vehicle.
R
Do not start the vehicle and do not release the
electric parking brake.
R
Do not open or close any doors or the tailgate.
398 Wheels and tires