Fitting/removing the hub cap
Removing
#
Remove socket
2
and wheel wrench
3
from
the vehicle tool kit.
#
Position socket
2
on hub cap
1
.
#
Position wheel spanner
3
on socket
2
.
#
Using wheel spanner
3
, turn hub cap
1
anti-clockwise and remove it.
Fitting
#
Before fitting, check hub cap
1
and the
wheel area for dirt, and clean if necessary.
#
Position hub cap
1
and turn until it is in the
right position.
#
Position socket
2
on hub cap
1
.
#
Position wheel wrench
3
on socket
2
and
tighten hub cap
1
.
%
Specified tightening torque: 25 Nm
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 665).
Important notes on using the jack:
R
Use only a vehicle-specific jack that has been
approved by Mercedes-Benz to raise the vehi-
cle.
R
The jack is only designed for raising and hold-
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
R
The foot of the jack must be positioned verti-
cally under the jack support point.
666 Wheels and tyres
ohne
Summary of Contents for EQS 2021
