%
When you switch off the vehicle, the last
speed stored is deleted.
When you activate cruise control or Active
Distance Assist DISTRONIC, the last speed
stored for the variable limiter is deleted.
Increasing/decreasing the stored speed
#
To increase the stored speed: swipe upwards
from the bottom of control panel
1
.
R
The stored speed is increased by 1 km/h.
#
To decrease the stored speed: swipe down-
wards from the top of control panel
1
.
R
The stored speed is decreased by 1 km/h.
or
#
Briefly press
M
or
N
on control panel
1
.
The stored speed is increased or decreased to
the next increment of ten (e.g. to 50 km/h or
60 km/h).
or
#
Press and hold
M
or
N
on control panel
1
.
The stored speed is increased or decreased to
the next increment of ten and afterwards by
increments of 10 km/h.
or
#
Accelerate the vehicle to the desired speed.
#
Press
M
on control panel
1
.
%
When the variable limiter is switched to pas-
sive mode, you cannot increase or decrease
its stored speed in increments of 1 km/h.
Adopting a detected speed
If cruise control/variable limiter is activated and
Traffic Sign Assist has detected a speed restric-
tion sign with a maximum permissible speed and
this is displayed in the driver's display:
#
Press
J
.
The maximum permissible speed shown by the
traffic sign is stored and the vehicle maintains
or does not exceed this speed.
Deactivating cruise control or the variable limiter
#
Press
±
.
%
If you brake, deactivate ESP
®
or if ESP
®
inter-
venes, cruise control is deactivated. The varia-
ble limiter is not deactivated.
%
When you switch off the vehicle, the last
speed stored is deleted.
When you select cruise control or Active Dis-
tance Assist DISTRONIC, the last speed
stored for the variable limiter is cleared.
▌
Information on the permanent limiter
If the vehicle should never exceed a specific
speed (e.g. for driving in winter tyre mode), you
can set this speed with the permanent limiter.
You do this by limiting the speed between
160 km/h and 240 km/h in the multimedia sys-
tem (
/
page 43).
Shortly before the set speed is reached, it
appears in the driver's display. When you confirm
the message, display messages no longer appear
until you switch off the vehicle. The speed will
only be displayed again once the vehicle has been
restarted or if the set speed is changed.
The permanent limiter does not switch to passive
mode even during kickdown and the driven speed
remains below the set speed.
332 Driving and parking
ohne
Summary of Contents for EQS 2021
