#
Place the key
1
in the marked space
2
on
the symbol .
The vehicle will start after a short time.
When you remove the key
1
from the marked
space
2
, the vehicle can be driven. For fur-
ther engine starts however, the key
1
must
be located in the marked space
2
on the
symbol during the entire journey.
#
Have the key
1
checked at a qualified spe-
cialist workshop.
If the vehicle does not start:
#
Place the key
1
in the marked space
2
and
leave it there.
#
Depress the brake pedal and start the vehicle
using the start/stop button.
%
You can switch on the power supply or the
vehicle with the start/stop button.
Observe any information regarding display mes-
sages that can be displayed on the driver's dis-
play.
Running-in notes
To preserve the engine during the first 1,500 km:
R
Drive at varying road speeds and engine
speeds.
R
Do not drive at speeds greater than
140 km/h.
R
Drive the vehicle in drive program
A
or
;
.
R
Shift to the next highest gear at the very latest
when the needle reaches the last third before
the red area in the rev counter.
R
Do not shift down manually in order to brake.
R
Avoid overstraining the vehicle, e.g. driving at
full throttle.
R
Only increase the engine speed gradually and
accelerate the vehicle to full speed after
1,500 km.
This also applies when the engine or parts of the
drivetrain have been replaced.
Please also observe the following running-in
notes:
R
In certain driving and driving safety systems,
the sensors adjust automatically while a cer-
tain distance is being driven after the vehicle
has been delivered or after repairs. Full sys-
tem effectiveness is not reached until the end
of this teach-in process.
R
Brakepads, brake disks and tyres that are
either new or have been replaced only achieve
optimum braking effect and grip after several
hundred kilometres of driving. Compensate for
the reduced braking effect by applying greater
force to the brake pedal.
R
In certain driving and driving safety systems,
the sensors adjust automatically while a cer-
tain distance is being driven after the vehicle
has been delivered or after repairs. Full sys-
tem effectiveness is not reached until the end
of this teach-in process.
R
Brakepads, brake disks and tyres that are
either new or have been replaced only achieve
optimum braking effect and grip after several
hundred kilometres of driving. Compensate for
266 Driving and parking
ohne
Summary of Contents for EQS 2021
