Mercedes-Benz Actros 2017, Operating Instructions Manual

Page: 73 / 436

Vehicles with BigSpace/StreamSpace/
GigaSpace cab
Vehicles with BigSpace/StreamSpace/GigaSpace
cab
X Remove flat-blade screwdriver (blade width
4 mm) from the vehicle tool kit.
X
Pull out insect screen
;
by the handle to the
centre of the roof frame.
X Turn guide rod
:
of insect screen
;
and
remove it on both sides of the blind guides in
the roof frame.
X
Guide insect screen
;
carefully back until it
stops, and hang it in the cab.
X If necessary, press the insect screen against
the roof frame and insert flat-blade screw-
driver
?
through opening
=
and position on
the actuator motor.
X Turn flat-blade screwdriver
?
anti-clockwise
until the pop-up roof is completely closed.
X
Remove flat-blade screwdriver
?
and
replace it in the vehicle tool kit.
X
Insert guide rod
:
of insect screen
;
in the
blind guides of the roof frame, turn it parallel
to the end position and guide the blind back
into the end position.
Roof hatch
You can open the roof hatch at one end (at the
front or rear) or at both ends (at the front and
rear).
X
Push the roof hatch up or pull it down by han-
dles
:
.
Roller sunblind
If you switch the ignition lock into drive position
while the roller sunblinds are not in the extreme
upper position, a reference run starts and the
roller sunblinds are retracted completely.
X
Switch the ignition lock to the drive position.
X
To extend: briefly press the
¥
or
§
button downwards.
The roller sunblinds extend to the extreme
position.
or
X
Press the
¥
or
§
button downwards
until the corresponding roller sunblind has
reached the desired position.
Roller sunblind
71
Opening and closing
Z