Mercedes-Benz Actros 2017, Operating Instructions Manual

Page: 65 / 436

ATA monitors:
R
on the tractor vehicle:
-
the doors
-
the exterior flaps
-
the power supply
-
the cab tilt lock
-
the vehicle interior (can be deactivated)
-
the maintenance flap
-
the fuel tank
R
the box-type bodies
R
the 24 V power supply of the trailer/semi-
trailer
Vehicles for the transport of hazardous goods: if
ATA is primed and the power supply is interrup-
ted using the battery isolator switch
(
Y
page 102), the alarm is triggered. The on-
board computer displays an according message
in an event window.
Bear the following in mind:
R
When ATA is primed, it confirms the locking
procedure by flashing all turn signals three
times. If the turn signals do not flash three
times, one or more components are not in the
rest position. ATA cannot then monitor these
components, e.g. open exterior flaps.
R
Components that are moved to the rest posi-
tion within approximately 30 seconds of ATA
being primed will be monitored.
R
If you subsequently close the exterior flaps
and want to include them in the monitoring,
prime ATA again.
ATA alarm
If ATA triggers an alarm:
R
all turn signals flash for approximately
5 minutes and
R
the alarm siren sounds for approximately
30 seconds
If you turn the ignition lock to the drive position
after an alarm has been triggered, the on-board
computer displays the alarm trigger data along
with the date and time in an event window.
Before ATA is primed
X Close the roof hatch, sliding sunroof or pop-
up roof.
X
Close the windows.
X
Draw back the curtains.
X Close the exterior flaps.
X Detach/remove any loose objects in the cab,
e.g. mascots or coat hangers.
Priming and deactivating ATA
Priming ATA with interior motion sensor
G
WARNING
Limbs could get trapped if they are in the
sweep of the sliding sunroof/pop-up roof
when opening and closing. There is a risk of
injury.
Make sure that no one's limbs are in the
sweep of the sliding sunroof/pop-up roof
when opening and closing.
If someone does get trapped:
R
release the button immediately or
R
press the top of the button again
The closing procedure is stopped.
G
WARNING
While closing the side windows, body parts in
the closing area could become trapped. There
is a risk of injury.
When closing make sure that no parts of the
body are in the closing area. If somebody
becomes trapped, release the switch or press
the switch to open the side window again.
ATA button with indicator lamp and panic alarm
X
Remove the key from the ignition lock.
X
Turn the integrated key to the locking position
in the door lock of the driver's door and hold it
for approximately 2 seconds.
Then turn the integrated key back to the rest
position and remove it.
Locking system
63
Opening and closing
Z