Mercedes-Benz Actros 2017, Operating Instructions Manual

Page: 419 / 436

Useful information
These Operating Instructions describe all the
models and standard and optional equipment of
your vehicle that were available at the time of
going to print. Country-specific differences are
possible. Bear in mind that your vehicle may not
be equipped with all the functions described.
This also applies to safety-relevant systems and
functions.
Read the information on qualified specialist
workshops (
Y
page 31).
Vehicle identification plate/axle
loads
Vehicle identification plate and vehi-
cle identification number (VIN)
Vehicle identification number (VIN) and vehicle
identification plate (example: Actros cab with flat
floor)
Vehicle identification plate
:
is located in the
door frame on the co-driver's side. Vehicle iden-
tification number (VIN)
;
is stamped on the
longitudinal frame member in the right wheel
housing.
Information on the vehicle identifica-
tion plate
Example: vehicle identification plate
:
Vehicle manufacturer (Daimler AG)
;
EU general operating permit number (only in
certain countries)
=
Vehicle identification number (VIN)
?
Permissible gross weight (kg)
Permissible gross vehicle combination
weight (kg)
A
Permissible axle loads of axles 1 to 4 (kg)
B
Permissible load of axle group T (kg)
C
Flue gas coefficient
D
Rear axle ratio
E
Basic headlamp setting
F
Type of vehicle or vehicle model designation
You will find the technically permissible gross
vehicle combination weight on the vehicle iden-
tification plate or in the COC documents. Note
that, in ADR mode, the technically permissible
gross vehicle combination weight is set by the
continuous brake effect of the vehicle. You will
find this value in your ADR certification.
If you require further assistance, consult a
Mercedes-Benz Service Centre.
Vehicle identification plate/axle loads
417
Technical data