Mercedes-Benz Actros 2017, Operating Instructions Manual

Page: 373 / 436

On vehicles with 2 fire extinguishers, the second fire extinguisher may be in the following storage
locations, depending on the vehicle version:
R
in stowage compartment
:
on the co-driver's side
R
in tool kit compartment
=
(
Y
page 369)
R
in a protective box on the exterior of the rear wall on the driver's side
On the L cab as car transporter: with lowered berth or seat/berth combination, the fire extinguisher
and jack are behind the driver's seat. You are responsible for stowing the tools yourself.
On the S cab, the jack is on the B-pillar behind the co-driver; the vehicle tool kit is behind the driver's
seat. For all vehicles except those on the French market, the fire extinguisher is on the engine tunnel
on the rear wall. For vehicles on the French market, the fire extinguisher is on the A-pillar on the co-
driver's side. You are responsible for stowing the tools yourself.
The following emergency equipment is found in the stowage space in the driver's door:
R
first-aid kit
R
warning triangle
R
warning beacon
R
reflective safety vest
Jack
i Depending on the equipment, the jack has a
maximum weight of 15.9 kg.
The maximum jack payload can be found on
the sticker attached to the jack.
Following a malfunction, please contact a
qualified specialist workshop.
Jack maintenance
X After usage: clean all moving parts and reap-
ply grease to them.
X
Every six months: completely extend and
retract the piston.
Pump lever (2-part)
G
WARNING
If you do not assemble the pump lever as
described, the handle can slip out of the guide
while pumping. There is a risk of injury.
Make sure that the locking pin of the pump
lever is engaged in the hole intended for the
purpose.
:
Recess (jack)
;
Jacking point (wheel wrench/cab tilt pump)
=
Retaining pin
?
Recess (for operating the winch and jack)
A
Hole for retaining pin
B
Retaining sleeve for inserting the hand crank
(spare wheel hoist)
Use the pump lever to operate:
R
the jack
R
the wheel wrench
R
the spare wheel winch
R
the cab tilt pump
X
To assemble the pump lever: align and
insert retaining pin
=
into hole
A
of both
pump lever parts.
X Press retaining pin
=
into hole
A
until it
engages.
X
To disassemble the pump lever: press lock-
ing pin
=
and pull apart the pump lever.
Where will I find...?
371
Breakdown assistance
Z