Mercedes-Benz ACTROS 2002, Operating Instructions Manual

Page: 510 / 620

505
Practical advice
Electrical system
1
2
3
4
5
6
7
8
9
Replacing a lamp
To prevent a short circuit, switch off
lighting before replacing lamps.
Use only 24 Volt lamps of same type
and of same wattage.
Do not work with oily or moist hands.
Hold lamps with a clean, lint-free cloth
only.
Check contacts for corrosion and clean
if necessary.
Check that all seals are sitting correct-
ly. Replace damaged housing seals.
If the new lamp still does not function after
replacement, have the lighting examined in
an authorised specialist workshop.
DaimlerChrysler recommends that you vis-
it a Mercedes-Benz Service Centre as it
has the necessary specialist knowledge
and tools for the work required. For work
relevant to safety and work on safety-
related systems in particular, it is essential
that maintenance work is carried out at a
qualified specialist workshop.
Overview of lamps
Exterior lighting
i
Have the headlamp setting regularly
checked.
Main headlamps
Main-beam headlamps H1 24 V 70W
Dipped-beam headlamps H7 24 V 70W
Turn signal lamp, front PY 21W
Side lamp/parking lamp W 5W 24 V
Turn signal /
perimeter, front side P 21/ 5W
Front foglamp
(additional headlamp)
H3 24 V 70W
Perimeter, roof front C 5W