X
Turn the SmartKey to position
2 in the
ignition lock.
X
To open: press the corresponding switch.
X
To close: pull the corresponding switch.
i
If you press the switch beyond the point
of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by pressing again.
i
You can continue to operate the side
windows after you switch off the engine.
This function remains active for five
minutes or until one of the front doors is
opened.
You can ventilate the vehicle before you start
driving. To do this, you can use the key to
simultaneously:
R
open the side windows
R
open the tilt/sliding sunroof or the
panorama roof with power tilt/sliding
panel and the roller sunblinds
R
switch on the seat ventilation of the driver's
seat
i
The convenience opening feature can
only be operated using the key. The key
must be near the handle of the driver's
door.
X
Point the tip of the key at the driver's door
handle.
X
Unlock the vehicle by pressing the
%
button.
X
Press and hold the
%
button until the
side windows and the tilt/sliding sunroof
or panorama roof with power tilt/sliding
panel are in the desired position.
If the roller sunblinds of the panorama roof
with power tilt/sliding panel are closed, the
roller sunblinds are opened first.
X
Press and hold the
%
button again until
the panorama roof with power tilt/sliding
panel is in the desired position.
X
To interrupt the convenience opening
procedure: release the
%
button.
Convenience closing
When you lock the vehicle, you can
simultaneously:
R
close the side windows
R
close the tilt/sliding sunroof or the
panorama roof with power tilt/sliding
panel
On vehicles with a panorama roof with power
tilt/sliding panel, you can then close the
roller sunblinds.
When closing the door windows and the tilt/
sliding sunroof or panorama roof with power
tilt/sliding panel, make sure there is no
danger of anyone being harmed by the closing
procedure.
If potential danger exists, proceed as follows:
R
Release button
&
to stop the closing
procedure. To open, press and hold button
%
. To continue the closing procedure
after making sure that there is no danger of
anyone being harmed by the closing
procedure, press and hold button
&
.
Vehicles with KEYLESS-GO:
R
Release the sensor surface on the outside
door handle to stop the closing procedure.
R
Immediately pull on the same outside door
handle and hold firmly. The door windows
and the tilt/sliding sunroof or panorama
roof with power tilt/sliding panel will open
for as long as the door handle is held but
the door not opened.
Side windows
93
Opening and closing
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi
Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 93
Z
