from the transmitter button that you are
programming. Try different angles from a
distance of 2 to 12 inches (5 to 30 cm) or
the same angle from differing distances.
R
If there is another garage door remote
control for the same device, perform the
programming steps again using the remote
control. Before performing these steps,
make sure that new batteries have been
installed in the garage door remote control.
R
Align the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.
Opening or closing the garage door
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.
X
Turn the SmartKey to position
2 in the
ignition lock.
X
Press transmitter button
;
,
=
or
?
in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with fixed code:
indicator lamp
:
lights up continuously.
Garage door system with rolling code:
indicator lamp
:
flashes briefly and then
lights up for approximately two seconds.
This is repeated for up to 20 seconds.
i
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and
indicator lamp
:
will flash. Press the
transmitter button again, if necessary.
Clearing the remote control memory
X
Turn the SmartKey to position
2 in the
ignition lock.
X
Press and hold transmitter buttons
;
and
?
for approximately 20 seconds until
indicator lamp
:
flashes rapidly.
The memory is cleared.
i
You should clear the remote control
memory before selling the vehicle.
To obtain correct direction display in rear-
view mirror
:
, the compass must be
calibrated and the magnetic field zone set.
X
To call up the compass: briefly press
button
=
.
The compass indicates the direction in
which the vehicle is currently driving:
N
,
NE
,
E
,
SE
,
S
,
SW
,
W
or
NW
.
X
To calibrate the compass: determine
your position using the following the zone
maps.
Features
303
Loading, stowing and features
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi
Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 303
Z
