85-03-01205
ML-SERIES FIREPLACE
Page
75
5.5.4
Icon Details
Mode Button:
Pressing the mode button toggles between the various available functions: flame height, fan speed,
accent light intensity.
Flame Height:
Six flame height levels are available. While the flame height icon
is displayed, pressing the up or down button once will increase or decrease the
flame height by one of six increments.
If the flame height is at Level one and the down button is pressed, all burners
will turn off.
If in IPI mode, the pilot will also extinguish.
If in CPI mode, the pilot will remain on.
Note: If in Smart Thermostat, the flame height function is not available for manual
adjustment. In Smart Thermostat, the flame height regulates automatically.
Fan Speed Control:
The fan speed can be adjusted through six speeds and off.
To activate this function, press the Mode button until it displays the fan icon. Use
the up/down arrow button to turn on, off, or adjust the fan speed. Once you set
the desired fan control, the system will remember your selected fan speed until
you manually change it.
Accent Light:
This function controls the accent light functions. Pressing the
UP button in this mode will turn on the accent light and allow you to control
the 6 levels of intensity. Once you set the desired light intensity, the system
will remember your selection until you manually change it.
(ML72 ONLY) Rear Burner:
This function controls the rear burner on/off
feature. Pressing the up button in this mode will turn on the rear burner and
pressing the down button will turn off the rear burner. The flame height of the
front burner will not change when you turn the rear burner on or off. The flame height can
only be changed in the Flame Height mode.
5.6
HOW DO I CHANGE FROM CELSIUS TO FAHRENHEIT?
To change between °C to °F, follow these steps:
1.
Press the ON/OFF button and turn off the fireplace.
2.
Simultaneously, press both the mode button and the thermostat button.
3.
Look at the LCD display to verify that your desired indicator (
°
F or
°
C) is being displayed.
If not, repeat Step 2.
