Memotec NetPerformer SDM-9120 Series, Hardware Installation Manual

Page: 85 / 161

Product Description
Memotec Inc. 4-17
4.9 Power Supply
The power supply is located on the right side when the SDM-9XXX Series unit is viewed
from the rear. A different power supply is provided on the UAC and DC units.
NOTE:
For information about the factory-supplied power cable and connection to the
power source, turn to “Powering the Unit” on page 3-29 .
4.9.1 SDM-9120 UAC
•
AC power connector
•
Voltage: Auto-sensing 100-240 VAC
•
Frequency: 50/60 Hz
•
Current: 0.8 A at 100 V and 0.4 A at 240 V
•
Maximum power consumption: 50 Watts
4.9.2 SDM-9220 UAC and SDM-9230 UAC
•
AC power connector
•
Voltage: Auto-sensing 100-240 VAC
•
Frequency: 50/60 Hz
•
Current: 0.8 A at 100 V and 0.4 A at 240 V
•
Maximum power consumption: 50 Watts
NOTE:
Normal power consumption may be lower when the unit is not fully populated.
4.9.3 SDM-9140 UAC
•
AC power connector
•
Optional Hot-Swap Redundant AC Power Supply (1+1)
•
Voltage: Auto-sensing 90-264 VAC
•
Frequency: 47-63 Hz
•
Current: TBD
•
Maximum power consumption: TBD