OWNER'S MANUAL
MODEL
DCD6006-PIR-A
4 5
1
3
6
7
8
9
11
10
14
13
12
2
SAFETY PRECAUTIONS
LOCATION OF CONTROLS
POWER SOURCES
OPERATION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to alert
the user to the presence of uninsulated
dangerous voltage within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
DANGER:
This product utilizes a Class 1 laser to read
Compact Discs. This laser Compact Disc Player
is equipped with safety switches to avoid
exposure when the CD door is open and the
safety interlocks are defeated. Invisible and hazardous laser
radiation when open and interlock failed or defeated. Avoid
direct exposure to beam. Please do not attempt to defeat or
bypass the safety switches.
FCC WARNING:
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment
may cause harmful interference unless the
modifications are expressly approved in the instruction
manual. The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
INFORMATION:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
• Do not open the CD compartment while the CD is rotating.
• Always keep the CD compartment closed when not in use.
• Keep all foreign objects out of the CD compartment.
• Place the unit on a stable surface.
• Avoid installing the unit in locations described below:
• Places exposed to direct sunlight or close to heat radiating
appliances such as electric heaters.
• On top of other stereo equipment that radiates too much
heat.
• Places lacking ventilation or dusty places.
• Places subject to constant vibration.
• Humid or moist places.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connec-
tion. Lightning and power surges ARE NOT covered under
warranty for this product.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada."
1. PHONES Jack (Side
of Unit)
2. DC 4.5V Jack (Rear of
Unit)
Z
3. PHONES Jack (Side
of Unit)
4. VOLUME Control
5. DBBS Switch
6. CD Door OPEN
Switch
7. SKIP/SEARCH (
o
)
Button
8. SKIP/SEARCH (
n
)
Button
9. MODE Button
10.CD Compartment,
Faceplate and
Transparent Lid
11.Display
12.STOP (
■
)/POWER
OFF Button
13.PLAY/PAUSE
(
®p
)/POWER ON
Button
14.Battery Compartment
(Bottom of Unit)
BATTERY INSTALLATION
The battery low indicator will blink in the
display when the batteries need
replacing
1. Open the battery compartment door
by pressing out and then lifting up.
To prevent the possibility of losing
the cover, it cannot be removed.
2. Insert two (2) “AA” batteries (not included) according
to the polarity diagram inside the battery
compartment. Alkaline batteries are recommended for
the longest playing time.
AC OPERATION
To operate the unit using AC power, connect an AC
adapter (not included) to an AC outlet having 120V, 60Hz
AC only. Plug the small end into the DC 4.5V jack on the
rear of the unit and connect the other end into an AC
outlet. The batteries are automatically disconnected when
an AC adapter is used.
CAUTION
: When not using AC
power, disconnect the AC adapter from the wall outlet by
pulling the plug (not the cord). Do not touch the AC
adapter with wet hands. Fully insert the plug without
exposing any part of the blade.
–
+
–
+ –
+
–
+
60 SECOND MOTION PROOF ELECTRONIC
ANTI-SHOCK SYSTEM
This CD player has a built-in Anti-Shock System that cuts down
on CD skipping, which is useful when using the CD player in the
car or while jogging/walking. Anti-Shock is automatically
activated when the unit is turned on.
HEADPHONE JACKS
There are two sets of headphone jacks. Plug headphones in
one jack for private listening or both jacks for sharing.
CHANGING THE FACEPLATE
1. At the top of the CD door, there is a transparent lid. Rotate
the lid clockwise to remove it.
2. Change the Faceplate with another, or insert your own
photo as desired. Make sure the tab on the Faceplate is
correctly positioned to the tab cavity on the CD door.
3. To replace the transparent lid on top of the CD door,
make sure the logo on the lid is at the correct position,
then rotate the lid counter-clockwise.
TO PLAY A CD (Standard, CD-R and CD-RW)
1. Open the CD compartment lid by sliding the CD OPEN
switch to the right. Gently press a disc, label side up,
onto the spindle until it locks in place. Close the CD
compartment lid. Insert headphones into the PHONES
jack.
2. While the unit is off, press the PLAY/PAUSE
(
®p
)/POWER ON button to start playback.
To pause
playback
, press the PLAY/PAUSE (
®p
)/POWER ON
button again, the elapsed time will blink. Press once
again to resume playback.
3. Adjust the VOLUME control and DBBS switch (to
enhance the bass) as desired. To
skip
forward or
backward through the tracks on the disc, press the
SKIP/SEARCH
O
or
N
button. To
search
forward or
backward through the tracks on the disc, press and hold
the SKIP/SEARCH
O
or
N
button.
4. When the disc is through playing, it will stop. Press the
STOP (
■
)/POWER OFF button to stop the disc before it
is finished; the total number of tracks will appear. Press
the STOP (
■
)/POWER OFF button again while in the
Stop mode to turn the unit off or wait approximately 30
seconds and the unit will automatically turn off.
NOTES:
•
This unit is capable of playing standard CDs or” singles;
no adapter is required.
•
If a disc is inserted incorrectly, dirty, damaged or not
present at all, the display will show “disc”.
•
As each track is played, the track number and elapsed
time are shown in the display.
•
To remove the disc, open the CD compartment while the
unit is in the Stop mode or off, then hold the edge of the
CD, gently press the center pivot and lift the CD.
• The maximum time of a CD is 74 minutes for this unit.
• “OPEN” will appear in the display when the CD door is
open.
MODE PLAYBACK
1. With a CD inserted, press the PLAY/PAUSE
(
®p
)/POWER ON button to turn the unit on, then select
a track using the SKIP/SEARCH
O
or
N
button (if
desired).
2. Press the MODE button once; the Repeat 1 indicator
1 will appear in the display. The unit will then play
the same track over and over until the STOP
(
■
)/POWER OFF button is pressed.
3. Press the MODE button a second time; the Repeat All
indicator
will appear in the display. The unit will
then play all the tracks on the CD over and over until the
STOP (
■
)/POWER OFF button is pressed.
4. While in the Stop mode, press the MODE button a third
time; the INTRO indicator will appear in the display. The
unit will play the first 10 seconds of each track. Press the
STOP (
■
)/POWER OFF button to stop Intro playback.
5. While in the Stop mode, press the MODE button four
times; the RAND indicator will appear in the display. The
unit will play all the tracks in random order. When all the
tracks have been played, the unit will stop. Press the
STOP (
■
)/POWER OFF button to stop Random
playback.
6. Adjust the VOLUME control and DBBS switch as
desired.
TO CANCEL
Mode Play, press the Mode
button until the indicators disappear.
WARRANTY
: 90 days parts and labor. For additional warranty
information or operating assistance, please visit
www.disneyelectronics.com
or contact customer service at
(954) 660-7026
. Please keep all packaging material for at least 90
days in case you need to return this product to your place of
purchase or Memcorp. For parts and accessories, contact Fox
International at 1-800-321-6993. Distributed by Memcorp Inc.,
Weston, FL, Disney Elements © Disney 2006.
ALL
ALL
English