Memjet Quadient Rena MACH 6, User Manual

Page: 6 / 132

SECTION 1
GETTING ACQUAINTED
2
Entry End & Connections View
1.
Media Side Guide - Inner – Used to guide inner edge of Media.
2.
Media Side Guide - Outer – Used to guide outer edge of media.
3.
Feeder/Entry Sensor Assembly (adjustable) – Contains two sensors.
Feeder Sensor is used to measure/monitor media length and control when next
piece feeds. Entry Sensor detects leading edge of media as it enters Print Engine
area. Adjustable position accommodates varying media widths/positions and to
avoid problem areas on media surface.
IMPORTANT : Be sure to position sensor assembly over media’s path.
4.
Sheet Separators (four) – Separates each piece of media as it is fed.
5.
Media Support Wedge Extensions – Narrow and Wide Media Support Wedge
Extensions are provided to accommodate a wider variety of different media widths
and lengths. They attach to the Rear Media Support Guide [7].
6.
Feed Rollers (twelve) – Delivers media from Feeder section into Print Engine area.
7.
Rear Media Support Guide/Sled – Helps to force media against sheet separation
area. Narrow and Wide Media Support Wedge Extensions attach to this device.
8.
Network Port – Ethernet cable attaches to Printer here
9.
USB Port – USB cable attaches to Printer here.
10.
Interface Port – DB-9 Interface to connect Printer with other equipment (future use)
11.
Main Power Switch, Receptacle and Fuse . – Plug in power cord here.
Switch turns main power ON/OFF. Fuse protects Printer’s electronic circuits
.
IMPORTANT! Press Soft-Power Button to power-down Print Engine. Wait until Soft-
Power Button light turns off before you turn off main power switch.
For best system performance, it is recommended to keep Print Engine
powered-up at all times.
7
1
2
3
4
6
5
Back
Panel
8
9
10
1