Memjet Quadient Rena MACH 6, User Manual

Page: 38 / 132

SECTION 3
OPERATING PRINTER
34
F
G
Adjust Rear Media Support Guide/Sled Assembly
1. Adjust Rear Media Support Guide [F] . Loosen the locking knob and slide Guide right or left, to center
Guide on the width of your media. Then secure locking knob.
2. Adjust Rear Media Support Sled [G]. Loosen locking knob and move Sled to desired position, to
raise/support trailing edge of media. Then secure locking knob.
Examples:
Sheet Paper - Raise media ~ 1.25" above Feed Table
#10 Envelopes – Raise media ~ 0.5" above Feed Table.
NOTE: Raising the media too high above the Feed Table
will cause loss of contact between media and feed rollers;
which can cause hesitation in feed. The Rear Media
Support Sled should be positioned so the media stack is
being held against the separation area while still providing
proper media to feed roller contact.
Guide/Sled Positioning Scales & Sled Safety Stop
Positioning scales are provided for your convenience. Once proper Guide/Sled positions are determined, for a
particular media/job, make a note of their positions. This will make Guide/Sled positioning easier to duplicate
when the same media/job is run at a later time.
NOTE : Scale values are in inches, but they do NOT correspond to a particular media width or length. Values are
for reference purposes only. Right-side (flat side) of the pointer is reference side.
A “
Safety Stop ” is provided to help prevent the Sled from moving past its zero position when the Rear Media
Support Guide is not at its zero position. Only when the Rear Guide is at its zero position, should the Sled be
moved past its zero position (into negative range).
Rear Guide at 1” position.
Sled should not pass zero position.
Rear Guide at zero position. Sled can move
past zero position, into negative range.