Mellanox Technologies SX6710, Hardware User Manual

Page: 35 / 112

Caution: After inserting a power cable and confirming the green System Status LED
light is on, make sure that the Fan Status LED shows green.
If the Fan Status LED is not green, unplug the power connection and check that the
fan module is inserted properly and that the mating connector of the fan unit is free of
any dirt and/or obstacles. If no obstacles were found and the problem persists, call
your Mellanox representative for assistance.
Mellanox Technologies
29
Figure 28: Two Power Inlets - Electric Caution Notifications
CAUTION
Risk of electric shock and energy
hazard. The two power supply
units are independent.
Disconnect all power supplies to
ensure a powered down state
inside of the switch platform.
ACHTUNG
Gafahr des elektrischen
Schocks. Entferrnen des
Netzsteckers elnes Netz-
teils spannungsfrei. Um
alle Einhieten spannungs-
frei zu machen sind die
Netzstecker aller Netzteile
zu entfernen
ATTENTION
Risque de choc et de danger

e’lectriques. Le de’branch-
ment d’une seule alimentation
stabilise’e ne de’branch
uniquement qu’un module
“Alimentation Stabilise’e”.
Pour isoler completement le
module en cause, Il faut
de’brancher toutes les alimen-
tations stabilise’es.
2.8 Bring-Up of Managed Systems
Note: In MLNX-OS, the physical management ports marked as 1 and 2 are referred to
as mgmt0 and mgmt1, respectively.
2.8.1
Configuring Network Attributes
The procedures described in this chapter assume that you have already installed and powered-on
the system according to the instructions in this document. Since the system comes with a pre-
configured DHCP, you may find the explanation in Section 2.8.1.1 sufficient. In case a manual
configuration is required, please refer to the instructions in Section 2.8.1.2.