SwitchX Switch EVB Hardware User Manual
Rev 1.5
Mellanox Technologies
59
Appendix D: Transferring the Power Cord
To use the rail kit to transfer the power cord from the connector side to the power side follow
these directions. Do you want to install power cords on both sides of the switch or only one side?
For each power cord you want to transfer:
1. Once you have decided which side of the switch will be next to the vertical support?
2. Make sure that you place the cord so that the correct end of the cord will be at the power side
of the switch. This will depend on which of the four mounting options you choose.
Figure 38: Transfer Power Cord
3. Put the power cord in the switch slide channel.
4. Push the cord end through the hole in the switch slide. Leave ~ 7” of cord hanging out from
the hole.
5. Screw the switch slides to the switch.
