Mellanox Technologies MetroX TX6240, Hardware User Manual

Page: 38 / 112

Installation Rev 1.1
Mellanox Technologies 38
Figure 23: Power Supply Unit Extraction
Figure 24: PS Unit Pulled Out

To insert a power supply unit:
Step 1.
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Step 2.
Insert the power supply unit by sliding it into the opening until a slight resistance is felt.
Step 3.
Continue pressing the power supply unit until it seats completely. The latch will snap into
place, confirming the proper installation.
Step 4.
Insert the power cord into the supply connector.
Step 5.
Insert the other end of the power cord into an outlet of the correct voltage.
Do not attempt to insert a power supply unit with a power cord connected to it.
The green power supply unit indicator should light. If not, repeat the whole procedure
to extract the power supply unit and re-insert it.
OK
!
!
OK OK
!
Latch release
Push Here