Melitta CI Touch, Operating Instructions Manual

Page: 35 / 306

Basic operation
35
GB
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.
3.4 Connecting the appliance
Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in
the technical data (see section 11,
page 51).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The socket must have a fuse of at least
10 A.
3.5 Switching on the appliance
for the first time
During initial start-up, the language, the
time and the water hardness can be set.
The settings can be changed at a later
point in time (see chapter 8, page 43
and section 9.8, page 49).
Use the enclosed test strip to determine
the water hardness. Observe the instruc-
tions on the test strip packaging and the
table in section 11, page 51.
Information
We recommend pouring away the first two
cups of coffee after initial start-up.
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Switch on the appliance with the ON/
OFF button.
» The welcome display appears on the
appliance.
» The request to carry out setup
appears on the display: Please set up
the machine .
3. Confirm setup with the "rotary switch".
» The Language menu appears.
4. Select your language with the "rotary
switch". Confirm your selection.
» The Clock menu appears.
5. Select the hour and the minutes with
the "rotary switch". Confirm your
settings.
» The Water hardness menu appears.
6. Select the determined water hardness
range with the "rotary switch" or con-
firm the default value.
» The request Please refill and insert
water tank appears.
7. Remove the water tank. Rinse out the
water tank with clean water. Insert the
new water filter (see section „Switching
on the appliance“ on page 36).
Fill the water tank with fresh water and
insert it.
» The appliance heats up and per-
forms automatic rinsing.
» The ready symbol and the request
Fill beans appear on the display.
8. Fill coffee beans into the bean con-
tainer. To do this, read section 4.4,
page 37.
4 Basic operation
This chapter describes basic operating
steps for using the appliance on a daily
basis.
4.1 Switching the appliance on
and off
Before switching on after starting up the
appliance for the first time, read sec-
tion 3.5.
Information
ū When switched on and off, the appli-
ance performs automatic rinsing.
ū During rinsing, rinsing water is also
conducted into the drip tray.
ū The automatic switch-off rinsing can be
switched on or off in the Settings menu.
Mel_009_CI_Touch_20_de--kr_druck.indb 35 14.09.2018 13:51:39