Melitta Avanza, Operating Instructions Manual

Page: 45 / 344

Changing basic settings
45
GB
Display Energy save
mode after:
Switch off after:
flash
30 minutes 8 hours
Information
Press any button to exit Energy Save
mode.
Requirement:
The appliance is ready for
operation.
1.
Press the "Service" button for
more than 2 seconds to call up Service
mode 1.
2.
Press the "Service" button
repeatedly until the display for the Auto
Off function appears.
3.
Press the "Coffee strength" button
repeatedly until the desired time is set.
4.
You can call up the next function
or exit Service mode:
a) Briefly press the "Service" button to
navigate to the next function.
b) Press the "Service" button for more
than 2 seconds to save the setting
and exit the service mode.
6.3 Setting the water
hardness
Setting the water hardness regulates how
frequently you are requested to descale
the appliance. The harder the water, the
more frequently the appliance has to be
descaled.
Information
Water hardness cannot be set while using
a water filter (see section 7.6 Using a water
filter on page 52). If a water filter is used,
the water hardness is set to soft.
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip packaging and in the
table Water hardness range on page 56.
The following settings are possible:
Display Water hardness
soft, descale after 150 litres
medium, descale after 100 litres
hard, descale after 70 litres
flash
very hard, descale after 30 litres
no
coffee beans
A water filter is used. No adjust-
ment is possible.
Requirement: The appliance is ready for
operation.
1.
Press the "Service" button for
more than 2 seconds to call up Service
mode 1.
2.
Press the "Service" button
repeatedly until the display for the
Water hardness function appears.
3.
Press the "Coffee strength" button
repeatedly until the desired water
hardness is set.
4.
You can call up the next function
or exit Service mode:
a) Briefly press the "Service" button to
navigate to the next function.
b) Press the "Service" button for more
than 2 seconds to save the setting
and exit the service mode.
6.4 Activating/deactivating
switch-off rinsing
Rinsing is always carried out immediately
after switching on the coffee system.
Only switch-off rinsing can be activated
or deactivated. If it is activated, the coffee
system is rinsed after being switched off.
Information
We recommend that you do not per-
manently deactivate switch-off rinsing,
because switch-off rinsing cleans the
coffee system.