Page | 16
Configuring the Intelli-Hood System
There are three different methods in which the user can configure the Intelli-Hood
system. It can be configured through the Touchpad, directly over the network using the
web-based configuration, or a configuration file can be uploaded through a USB Flash
drive. This section describes how to configure the system in each of these methods.
Configuration through the Touchpad
Refer to Section 5 in the Operation Manual for general tips on navigating the Touchpad.
The remainder of this document refers to Touchpad buttons as described in the
Operator’s Manual.
Follow these steps to unlock configuration.
1.
From the Touchpad’s Main Screen, press the “Menu” softkey to go to the Main Menu.
2.
While on the Main Menu, option 2 titled “System Configuration” is red to indicate that
configuration is locked. Press the Up and Down buttons at the same time and hold the buttons
down for ten seconds. “System Configuration” should change from red to blue to indicate that
configuration is unlocked. Release the Up and Down buttons at this point.
3.
Use the Down arrow to highlight the “System Configuration” option and press “Enter” to navigate
to the System Configuration.
For general navigation, the right softkey is used to navigate down into a new screen, the
Up and Down arrows are used to navigate options on a screen and the left softkey is used
to go back up one level.
Network Configuration through the Touchpad
If network settings need to be changed on-site, you most likely will need to change these
settings through the Touchpad as you may not be able to access the Intelli-Hood system
to perform web-based configuration. To navigate to the network settings:
1.
Unlock configuration as described previously.
2.
From the Main Menu, go to System Configuration->System to get to the general system settings.
3.
Navigate down to the network configuration settings. Changes are applied as soon as each item is
changed.
