Meler PS20, Instruction Manual, Page: 58 / 100

FOCKE MELER GLUING SOLUTIONS
5-2
MELTER OPERATION
Filling the tank
The tank can be equipped with a low level sensor (optional) that warns when
the level of hot-melt adhesive drops below a third of the tank’s capacity.
The unit will activate the external signal and, if it is connected, the
corresponding warning device (white colour).
Warning : Before refilling the tank, make sure that the adhesive is the same
type as that already in the tank. Mixing different types of adhesives can cause
damage to the melter equipment.
To fill the tank:
1. To do a concentric and circular cutting with diameter 210 mm in the
block base. This part will be in contact with the fuser grill.
2. Make two small cuts in the bag’s corners to get out the air.
3
4
2
1