Meler PS20, Instruction Manual, Page: 19 / 100

INSTALLATION
3-1
MA-5130-GBR PS20 NON STOP DRUM UNLOADER INHIBITION MANUAL
3. INSTALLATION
Warning: The melters are equipment with current technology and with certain
foreseeable risks. Therefore, only allow qualified personnel withsufficient
training and experience to use, install or repair this equipment.
Introduction
The PS20 Non Stop melters are delivered with all the materials necessary
for their installation. However, some components must be provided by the
user himself, according to the location and connections in each particular
installation:
• Anchoring screws for the melter equipment if required
• Power cord and plug for electrical power
• Pneumatic conduct and connection to the compressed air system
• Multicore cable for external electrical control
• Optionally, a gas ventilation system
Installation requirements
Before installing PS20 Non Stop melter equipment, we must make sure that
the space assigned to it permits installing, connecting and using the entire
system. Similarly, we must check to see that the electrical and pneumatic
supplies meet the necessary requirements of the melter equipment being
installed.
Free space
Item Description Dimensions
A DOOR OPENED 430 mm
B ELECTRICAL CABINET DISPLACEMENT 410 mm
C UNIT LENGTH 1150 mm
D UNIT LENGTH WITH FREE SPACE TO RIGHT SIDE DEVICES ACCESS 2080 mm
E UNIT HEIGHT 1825 mm
F UNIT WIDTH WITH FREE SPACE TO REAR SIDE DEVICES ACCESS 1510 mm
G UNIT WIDTH 510 mm