Meler PS 20 NON STOP+, Instruction Manual

Page: 74 / 100

FOCKE MELER GLUING SOLUTIONS
5-6
MAINTENANCE
Cleaning the push plate
1 Open the tank as explained in ‘Cleaning the bottom of tank.’
2 Place the piston in operational position. In this mode, the lower part of
the push plate becomes accessible for cleaning.
3 Lower piston. To do this, activate the solenoid valve manually from the
control display.
4 After cleaning, raise the piston by manually activating the solenoid
valve and carry out the other operations in reverse order.
Cleaning the distributor
1 Depressurise the equipment as explained in ‘Equipment
depressurisation’
2 Loosen the T-screws on the distributor. Each distributor is fixed by one
screw on the front section and two at the rear. The distributor descends
until it is supported on the sliding rails.
3 Loosen the shaft that joins the pump to the motor.
4 Pull the distributor to completely remove it and clean or replace it.
Warning: Hot zone with high temperatures. Risk of burns. Use thermal
protective equipment.
2
1
HMI : S02001100 v1.0.106
TC : S02200100 v1.0.084
IO : S02102100 v1.0.106
IO : S02101100 v1.0.106
STOP
HMI : S02001100 v1.0.106
TC : S02200100 v1.0.084
IO : S02102100 v1.0.106
IO : S02101100 v1.0.106
160 154
B
15:35
°C
08:31
2
00
154
1
85
1 2
B
A
VP
160
A
185 170 1
154 154 2
100 100 3
--- --- 4
5
42 42 6