
FOCKE MELER GLUING SOLUTIONS
INSTALLATION
3-4
Warning:
Make sure that the bench where the base plate is fastened is level,
free from vibrations and is able to support the weight of the equipment in
addition to the full tank load. Once the base plate is fastened in place on the
bench, the melter/applicator should be mounted on top of it.
Electrical power connection
‘’ series melters/applicators are designed to be connected to the
electrical power supply in three possible ways, depending on the power of
different elements connected:
• 1-phase 230 VAC with neutral
• 3-phases 400 VAC with neutral
• 3-phases 240 VAC without neutral
A good ground connection is required in all cases.
Consumption figures, according to melter/applicator and output configuration,
are included in the table. Due to high power connected Focke Meler
recommends 3-phases 400 VAC with neutral connection.
Warning:
Risk of electrical shock. Carelessness may cause injury or death.
Open the electric cabinet door as far as possible. Thread the power cord (max.
Ø18mm) through the electrical wall bushing (P) and fasten it to the inside
anchor, making sure that the cord reaches the power card connector at the
position where it will be installed.
Connect each wire in the power cord to its corresponding place on the power
intake connector on the power card.
Consumption values concerning each equipment can be found in the
characteristics plate.
L N PE L1 L2 L3 N PE
1/N ~ 230V 50/60Hz + PE 3/N ~ 400V 50/60Hz + PE
L1 L2 L3 PE
3 ~ 230V 50/60Hz + PE
WITHOUT
NEUTRAL
P
Summary of Contents for Micron + 10
