Meler MACRO FOAM Series, Instruction Manual, Page: 73 / 88

TECHNICAL CHARACTERISTICS
6-1
MA-5127-ENG MACRO FOAM SERIES MELTER MANUAL
6. TECHNICAL CHARACTERISTICS
General
Tank capacity
Pumping rate (*)
single pump
Melting rate (*)
Number of pumps
Number of hydraulic outputs
Number of electric outputs
Temperatures range
Temperature control
Max. working pressure (at 6 bar)
Max. power supply
one single pump
two single pumps
four single pumps
External functions
Electrical requeriments
Workplace temperature
Dimensions (LxWxH)
(*) Under standard conditions.
35 liters / 50 liters
1.6 ; 3.3; 6.6 cc/rev
35kg/h - 50 kg/h
Up to 4 single pumps
2 per pump
2 or 4 outputs (Standard version)
40 to 200°C (100 to 392°F)
RTD ±0.5°C (±1°F)
Pt-100 or Ni-120
80 bar (1.160 psi)
4.260 W / per phase (2 outputs)
5.560 W / per phase (4 outputs)
6.720 W / per phase (4 outputs)
Temperatures ok output
Low level signal
Standby input
External outlet inhibitor
Motor start up input
Foam Pump pressure control input
Failures in pumping card output
Low gas alarm output
External loader adhesive output
3N ~ 400V 50/60 Hz + PE
0 to 40 °C
1150x510x1825
120 liters
1.6 ; 3.3; 6.6 cc/rev
120 kg/h
Up to 4 single pumps
2 per pump
2 or 4 outputs (standard version)
40 to 200°C (100 to 392°F)
RTD ±0.5°C (±1°F)
Pt-100 or Ni-120
80 bar (1.160 psi)
6.060 W / per phase (2 outputs)
8.260 W / per phase (4 outputs)
9.010 W / per phase (4 outputs)
Temperatures ok output
Low level signal
Standby input
External outlet inhibitor
Motor start up input
Foam Pump pressure control input
Failures in pumping card output
Low gas alarm output
External loader adhesive output
3N ~ 400V 50/60 Hz + PE
0 to 40 °C
1150x875x1825