Meler Cantho, Instruction Manual

Page: 43 / 66

5-5
MAINTENANCE MA-5168-ENG ADHESIVE MELTER CANTHO
Thermostat maintenance
If either of the two thermostats is deactivated:
1. Disconnect the melter.
2. Remove the front cover (see ‘Removing the front cover of the melter’)
and press the button to reset it.
3. Loosen the four screws fastening the support panel of the connector.
Remove it carefully.
4. Press the corresponding button to reset it.
5. Refit the support panel and the front casing.
Remove the unit from its base
For more thorough maintenance of the equipment, the melter needs to be
removed from its location so that it can be handled with greater ease and
accessibility.
To do so, it must be removed from its location as follows:
1. Disconnect the electrical connections of the unit. If it has a Focke Meler
control box, disconnect the 24-pin connector from the unit.
2. Disconnect any pneumatic or electrical line that joins the unit to the
rest of the machine.
3. Remove the screws that fasten the unit to the machine support.
4. The unit is now removed and can be replaced or maintained offline.