Meler Cantho, Instruction Manual

Page: 32 / 66

FOCKE MELER GLUING SOLUTIONS
4-8
MELTER OPERATION
3. Press the button with the clock symbol once again.
Two times will appear, one in each display. The display on the left shows
the start time, while the display on the right shows the finish time.
4. The blinking dot next to the start time indicates that this is the value that
may be modified. Use the up-down arrow under the display to select the
desired value.
5. Press the button with the clock symbol once again.
The dot changes to the finish time.
6. Use the up-down arrow under the display to select the desired value.
7. Press the button with the clock symbol once again.
The selected program will appear once again. Use the up-down arrow
under the display to select other programs.
8. Pressing either the up or the down arrow for element selection will exit
this program and return to the tank temperature display.
The green LED next to the ‘ON/OFF’ button will remain blinking as long as there is
an equipment disconnection time programmed for the current day.
Disabling the equipment activation/deactivation program
It is possible to disable the equipment activation/deactivation programming
without canceling the daily programming. This way the programmed data is
saved, but the programming will have no effect on the equipment.
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day and
hour information.
2. Use the up-down arrow under the display to go past the selection for the
last day of the week (7).
The message ‘ON/OFF’ will appear on the display, depending on the
current status.
3. Press the button with the clock symbol once again.
The status will alternate each time you press the button.
4. Pressing either the up or the down arrow for element selection will exit
this program and return to the tank temperature display.
Programming the equipment’s standby function activation/deactivation
You may program an activation and a deactivation time for every day of the week,
from Monday (1) to Sunday (7).
Time is expressed in 15 minute increments, so we cycle from 10.0 (10 hours and
0 minutes) to 10.1 (10 hours and 15 minutes) to 10.2 (10 hours and 30 minutes) to
10.3 (10 hours and 45 minutes).
ON ON
OFF OFF
0 0
08.2 08.2 18.0 18.0
08.2 08.2 18.0 18.0
1 1
160 160 160 160
160 160 160 160