MEITRACK T633L User Guide
Copyright © 2021 Meitrack Group All rights reserved. - 12 -
12
(1-wire,
Digital
temperature sensor or
iButton input port)
Green
TTL3.3V level
Connect to the A52 digital temperature sensor or iButton by default
by using the A61 sensor box.
The port can be set to negative input 9 or output 4.
Note: The DC or AC voltage that is greater than 3.3 V is not allowed.
Otherwise, the device may be damaged.
3
First Use
3.1
Installing the SIM Card
1.
Loosen the screws, and remove the front cover of the device.
2.
Insert the SIM card into the card slot with its gold-plated contacts facing towards the Printed Circuit Board
(PCB).
3.
Close the cover, and tighten the screws.
Note:
⚫
Power off the device before installing the SIM card.
⚫
Ensure that the SIM card has sufficient balance.
⚫
Ensure that the phone card PIN lock has been closed properly.
⚫
Ensure that the SIM card in the device has subscribed the caller ID service if you want to use your authorized
phone number to call the device.
3.2
Configuring Device Parameters by Meitrack Manager
This section describes how to use Meitrack Manager (version 6.0.2.4 or later) to configure the device on a computer.
Procedure:
1.
Install the USB driver and Meitrack Manager.
2.
Connect the device to a computer by using the USB cable.
3.
Run Meitrack Manager, then the following dialog box will appear:
Turn on the device, then Meitrack Manager will detect the device model automatically and the parameter page will
appear accordingly.
For details about Meitrack Manager, see the
MEITRACK Manager User Guide
.
3.3
Installing GPS and GSM Antennas
Connect the GSM antenna to the connector which is labeled "GSM". The GSM antenna is non-directional, so you can
hide it in any place of a vehicle.
Connect the GPS antenna to the connector which is labeled "GPS". It is recommended that the antenna is facing up
