9680928
10 / 16
7
Safety instructions
Due to its working principle, the TopCut has a
sharp blade
at the front. In idle
position, the blade is covered by the cutting unit and is not exposed until the
washing chamber door is closed.
In case of direct manual actuation of the
TopCut there is a danger of injury by the blade!!
If the TopCut is bent due to improper use the blade may remain exposed after
actuation. In this case immediately disable the TopCut and secure against use!
Insert the bags into the holder; do not throw them as this could cause the door
to close unexpectedly!
If the bag is not correctly cut open, place the bag in the holder again so that it
is centred and cut the bag once more. If the TopCut again fails to cut, inform
an authorised member of staff.
After closing the chamber door, do not open it again, but immediately start the
program.
In case of service:
Caution on replacing the the blade:
Danger of injury!
Please observe proper use of the cleaning and disinfection device. Any other
use or operations could cause damage and risks for which we can accept no
responsibility.
Wear personal protection (rubber gloves). To avoid contaminating the door
handle and the control panel, you should remove your protective gloves after
filling the TopCut. Then disinfect your hands. Observe the operator's hygiene
plan.
Please read and observe the safety instructions and operating instructions for
the cleaning and disinfection device.
Before removing the TopCut, make sure that the blade has retracted correctly
and that the holder is free of soiling. In dismounted state, carry the Der TopCut
by the side facing the cutting unit. Do not use moving parts as a carrying aid.
Handle the TopCut with care. Do not throw, swing or drop the device
Do not use in machines with an automatic door! If it is used in machines with
an automatic door, the high load produced can result in damage to the door
mechanism and to the TopCut device itself.
For your own safety and to avoid any danger do
only
use original MEIKO spare
parts!
