57 / 64
9763258
3. "Show" the next date to change the filter, in 6 months' time with a standard
membrane (< 0.1 mg/l), in 3 months' time with a chlorine-resistant membrane
(≥ 0.1 and ≤ 2.0 mg/l). Use a permanent marker or similar for this. The picture
shows an example of a filter change date in July (marked: 7) 2014 (marked: 14)
9.4
Daily cleaning
Beware
Danger of burns and scalding due to hot rinse water, washware and machine
parts
Contact with hot rinse water, washware and machine parts can result in
burns/scalding of the skin.
• Wear protective gloves if necessary.
• Let the washware cool down before emptying, if necessary.
• Let the machine cool down before touching machine parts, if necessary.
• Never open the machine door or hood during a wash cycle.
• Only open and close the hood/door using the designated handle(s).
,
Caution
Material damage due to water ingress
Electrical cables and electronic components can be damaged if they come into
contact with water.
• The dishwashing machine, switch cabinets and other electrical components
must
never
be sprayed with a hose or high pressure cleaner.
• Make sure that no water can enter the machine unintentionally.
• If installed at ground level,
never
flood the surrounding room.
The machine is emptied, see section
see chapter “Shutting down the dishwasher”
on page 43.
1. Open machine door.
2. Remove filter and washing systems.
3. Remove all food residues which are stuck to the tank, the tank heater and the
filters using a brush.
4. Remove the washing and rinse arm and rinse thoroughly under running water.
When doing this, pay particular attention to the nozzles!
Do not use a foaming manual dishwashing detergent for pre-cleaning or for cleaning
the machine. Foam causes malfunctions and can result in a poor wash.
Summary of Contents for M-iClean U
Page 63: ...63 64 9763258 13 Notes ...
