Operating Instructions Tray washing machine Modell BTA 160 / 240
Datei:BA_BTA_9668415_EN_2009-10.docx
9668415
34/48
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
13.3 Cleaning instructions – daily
Do not use a high pressure cleaner!!!
Switch off the machine.
Open the doors.
Open the outlet.
Spray the machine’s
internal chamber.
Remove the tank cover
screens.
Remove the screen
supports
Remove the upper / lower wash systems and rinse arms
Remove the separation
panels.
Open the base drip tray of
the suction system and
clean it.
Clean the inner chamber
of the tank with a hose.
Spray the float valve
housing of the water level
monitoring.
Remove and clean the
screen on the suction side
of the pump.
Remove and clean the
outlet screen.
Remove and clean the
spray protection curtains.
Clean the wash and rinse arms and their jets.
Use a
nylon brush to clean the jets.
Check that the wash arms
and end caps are complete and water-tight.
Clean the outlet screen
and the pump screen
(suction side).
Clean all screens.
Close the base drip tray of
the suction system.
When you have cleaned the machine, replace all the parts; check that you have replaced them all and that they are in
the correct position.
Check that all wash arms are properly secured. Check that all wash arms are complete and in the correct
position.Check that all wash arms are complete and in the correct position. Replace the outlet stand-pipes and curtains.
Close the doors.
The machine, switch cabinets and other electrical components must NOT be sprayed with a hose or a high pressure cleaner.
Summary of Contents for BTA160
Page 48: ......
