Operating instructions wet waste treatment unit, Model AZP 80, AZ / AP 80
Datei:BA_AZP80_AZ_AP_9633432_EN_2005-10.docx
9633432
12/36
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Once the wet waste treatment unit has been installed, put into service and handed over
to the customer/operator, no modifications (electrical or location modifications, for
example) may be made. Modifications to the Wet waste treatment unit, and in particular
technical modifications carried out without the manufacturer’s written authorization, or any
modifications carried out by unauthorized persons, will lead to the complete loss of any
guarantee claims and will invalidate any liability for the product.
5.2
Basic safety measures
Danger can arise from the improper use of the machine or f it is used for purposes for
which it was not intended
Parts carrying electric current as well as moving or rotating parts can cause
•
Dangers to the user’s life and limb and
•
Material damage
The machine may only be operated by adequately qualified staff who have been trained
by the operating company and who have been trained about the Hazard and Safety
Instructions.
Qualified staff, as defined by the Operating Instructions, are persons:
•
who are over 14 years of age,
•
who have read and who observe the safety instructions,
•
who have read and who observe the Operating Instructions (or the part applicable to
the work to be carried out).
WARNING!
When electrical equipment is in operation, it is inevitable that certain parts carry a
dangerous current.
ALL current to the whole machine MUST be switched off before the machine’s cladding or
electrical equipment is opened.
PLACE THE MAIN SWITCH IN THE “OFF“ POSITION and install suitable security
measures to prevent the switch from being switched on.
Only specialist personnel may carry out repairs and rectification work on the electrical
part of the machine.
The Health and Safety Regulations must be observed
The perforated cylinder rinse operates with hot water. Avoid all contact with the rinse water
and with the perforated cylinder. Danger of scalding/burning!
The machine, switch cabinets and other electrical components must NOT be sprayed with
a hose or a high pressure cleaner.
Attention!
2 potential-free terminals for connecting a dosing unit are located in the switch cabinet.
These terminals are always live, even when the machine is switched off (separate
voltage source)!
Wet waste treatment unit may only be operated under the supervision of trained personnel.
If you are unsure about the operation of the machine, the machine must not be used.
ATTENTION!
ATTENTION!
ATTENTION!
ATTENTION!
ATTENTION!
ATTENTION!
