Working with the app
Before starting the app make sure all the sensors are physically installed according to
the instruction in this manual.
Start the ReachControl app. When a Controller is used (see chapter Controller, page 22),
depending on the version, the app may start automatically.
The app only supports portrait mode.
Getting started
1. Start the ReachControl app …
2. Select you preferred language ...
3. Read (optional) the information on the various information screens, tap ‘>’ to
continue to the next screen or tap ‘skip’ to skip the information screens …
4. Follow the instructions in the ‘Action required’ popup and tap ‘Settings’ …
5. Enable ‘Allow modifying system settings’, tap the ‘back’ button or ‘
’ …
6. Check ‘I agree with the terms and conditions’ and tap ‘>’ …
7. Select you hydraulic measurement application …
1. Choose ‘Cylinder’ for a generic, double acting hydraulic cylinder;
2. Choose KOOI-REACHFORKS® for any hydraulic telescopic lift truck fork;
3. Choose ‘Fork poistioner’ for a hydraulic fork positioner attachment;
4. Choose ‘Mast height extension’ for mast height extensions (MHEH / LFC)
attachment.
8. Tap ‘>’ …
9. Tap ‘ALLOW ONLY WHILE USING THE APP’ in the ‘Allow ReachControl to
access this device’s location’ pop-up. This permission is required for the app to
use the Android Bluetooth signal strength feature …
27
