Record:
After connection is ready (no matter composite, component, or HDMI), you will see the indicator light is
green, and the video will show on the screen.
The 720P/1080P quality LED will shows on 1080P default if the input source is 1080P, it means that you
can press the “720/1080” button to set 1080P file recording to 720P. When the 720P LED shows on, means the
recorded file will be 720P. If the input source is under 1080P, then the LED will only show on 720P, and the
“720/1080” button will not work, it means that it only can record 720P or under 720P file (base on input quality).
Record quality also can set by remote controller.
The source LED (HDMI/YPbPr/CVBS) will tern on according to the input source (both on for CVBS). Both
LED will be flashing if there is no video input or the input video with any problems. You can press “source”
button or remote controller to set the input source if there are more than two sources at the same time.
To record video is very simple --- press the record button (or remote controller), and then you will see the
REC indicator turns on, it means now recording. Use SNAPSHOT button of remote controller, you can get a still
image by one press, but it is only work when NOT recording.
Recording comments during video recording: If you connect a Microphone to MIC port, you can record
comments with video, and you can adjust the volume by the switch. There are several reasons for no actions when
press record button, you may need check:
1.
The input video source disconnected.
2.
The USB flash is out of memory.
3.
The format for USB flash is not suitable, e.g. exFAT. HVR-7000 support FAT, FAT32, and NTFS.
4.
The USB flash is not connected well.
5.
The USB flash is not ready, normally, it will take 4~8 seconds after plug it on.
To stop recording, just press the button again, will see REC indicator flash for few seconds and turns off, it
means the record is stopped, now you can take off your USB flash.
Note: please do not take the memory off when the indicator is flashing. The recording will
automatically stop if the USB flash out of space.
After stop recording, connect the USB flash to computer will see the recorded files: for 1080P recording, file will
be Encode_1080P_1, for 720 or 480p recording, file will be Encode_1.Every record/stop operation will create a
different recording file: Encode_1080P_1,Encode_1080P_2, Encode_1080P_3… and so on.
The max size per file will be around 1.95GB (around 15 minutes for 1080p video), when you record a video
more than 1.95GB(15 minutes), HVR-7000 will partition it in more than 1 file, for example: if you record a 45
minutes 1080p video by one click recording, you will see 3 files: Encode_1080P_1, Encode_1080P_1_1,
Encode_1080P_1_2…and so on
Sometimes you may find that some recorded video with problems, like: skip. It may caused by you are using
a USB flash on NTFS format, and you haven’t click “safety remove” the device when disconnect from computer
(especially for USB HDD, if not safety remove, may caused seriousproblem). You can try to format it to FAT32
if the problem keeps happen.
