CashFlow
®
540 changegiver Pocket Guide
,
MEI., 1997
13
No coins are dispensed
Levels of coins in the tubes are
below the safe count
Dispenser loom not connected, or
loose
Faulty dispenser module
Check that change coins are available in the tubes.
If necessary, float up the tubes with the correct change coins.
Switch off power to the machine and check that the
dispenser loom is fitted correctly. Refer to the Product
Maintenance Handbook.
Check that the dispenser module is operating correctly. Refer to
Maintenance Handbook’s module replacement section
before you attempt to service or to replace the dispenser.
Red LED is ON, except
when a vend is made
Normal operation
No action
Red LED is ON but coins
are not accepted
Coin jam in the changer mechanism
Lid of the acceptor is open
Not enough reject lever clearance
Check for jams in the acceptor and in the tubes. Clear the jams.
Press Mode+Mode to park the dispenser arms before
replacing the cassette, then dispense a coin from each tube to
check operation.
Switch off the power to the machine. Open and close the lid
of the acceptor, wait at least 15 seconds, then switch on
again.
Check clearance is between 2 - 3mm, and adjust if necessary.
Problem
Causes
Actions