Chapter
IV
Dex PM3000 23
Full-Digital Control CO2/MAG/MIG Multi-FunctionWelding Machine
1.
Press the "Welding Control" key, switch to Special 4T mode.
2.
Set parameter for arc starting, and detail can be seen in parameter for arc starting setting.
3.
Set parameter for arc ending, and detail can be seen in parameter for arc ending setting.
4.9
Storage and Invocation
Storage
Store the set welding parameter.
1.
Setting welding parameter, press "Storage"key.Storagelight will flashand channel light is on, can then
select storage channel number.
2.
Select channel number with panel knob, press "Execution" key, as shown in fig.4-10.
Fig.4-10 Storage Setting Interface
Attention
1.
After welding machine to restore factory settings, storage parameter is not clear operation.
2.
If not to press "Execution" key to confirm in storing process, parameter will not be save.
3.
When storage channel is full, new storage channel number will cover the originals.
4.
When storage channel is the same one, new storage channel number will cover the originals.
Invocation
Invocatethe saved welding parameter.
1.
Long press "recall" key, LED light is flashing, and enter parameter invocation mode.
2.
Select invocation JOBnumber (0~49) with panel knob, press "Fn" key, as shown in fig.4-11.
Fig.4-11
Invocation Setting Interface
4.10
InternalMenu
Press “Fn” key to enter into internal menu.
Step
Step
Step
Step
