MegaPoints Controllers
System2 Relay-8 User Reference
Revision 1
megapointscontrollers.co.uk
Page 27
Relay R1 is configured for events on V-Port 321 and ill trigger when the Servo-8 is halfway.
This can be freely changed to respond to the same ports as the push button or any other device. It
can also provide feedback data of its own, however setting the Feedback V-Port to “0” disables
feedback from the relay.
Finally on the Network Monitor we observe the last packet at minute 17. It’s addressed to V-Port
161 and this time contains a 0 in the D3 column. This tells the Panel Controller to stop flashing as the
servo has reached its final position.
Skipping ahead to the last packet on the report you can see its to V-Port 161 and contains a 1 under
the D3 column. This is the polar opposite of the previous paragraph and indicates the servo has
reached the opposite end of motion and sets the Panel Controller indicator appropriately.
At the bottom of the network monitor page are some packet
statistics. The leftmost column indicates the peak and current
number of packets per second. The right most column shows the
sae data over a one minute interval.
Status area
The status area shows information at the board level and is display only.
Board Type (1)
This tells you what the board is. In this case a servo-8.
